Maintenance of Rain Star Machine
2016-12-06
1、 Daily maintenance 1. Reciprocating screw and slider: clean dirt, add lithium based grease, and maintain every 250 hours; 2. Drive chain: Clean dirt, add lithium based grease, and maintain it every approximately 250 hours; 3. Transmission: change the Gear oil for 500 hours for the first time and once a year thereafter; 4. Tires: Inflate when the air pressure is insufficient. The standard air pressure of the main engine tires is 0.5MPa (0.35MPa), and the driving tires are 0.25MPa; 5. Front support leg: Add lithium based lubricating oil every six months or as needed; 6. Water turbine: At the end of the irrigation season, loosen the drain plug of the water turbine and drain the accumulated water in the water turbine; 7. Reel bearing seat: Add lithium based lubricating oil every 500 hours; 8. Close the rod sliding plate: clean the dirt as needed and add lithium based lubricating oil; 9. Slewing bearing: Add lithium based lubricating oil every 500 hours; 2、 Winter maintenance 1. Before the temperature drops to 0 ℃, remove the connecting hose of the sprinkler crane and use an air compressor with a pressure of 0.25MPa and an output of 800L/min to connect Connect to the water inlet of the machine and blow out the water from the PE pipe. (When blowing water, the PE pipe must be wrapped around the reel, and empty PE pipes are never allowed to be recycled) 2. After blowing out the water from the PE pipe, use a wrench to unscrew the drain plug at the bottom of the water turbine to drain the accumulated water from the water turbine, and then install it again when it is used next time. 3. Remove the connecting hose, drain any accumulated water inside the hose, brush off the soil on the outer surface, roll up the hose, and store it in a dry, ventilated, and dark place. 4. Clean the machine thoroughly, apply lithium based grease to the required areas, and place the machine in a sheltered and rainproof area. Do not expose it directly outdoors. 5. Pay attention to the oil level of the transmission oil window to ensure that Gear oil can be observed at the oil window, or fill Gear oil to the oil window. |